Connect the network device the ethernet port the wall plate
Passing Score: 80%
View results by: | ![]() |
Objective Analysis | ![]() |
---|
|
Launch Lab | |
---|---|---|
You did not complete the lab correctly.
[netpro2015_lab_questions_en.exm EXM_CONNECT]
You are working on a small office/home office (SOHO) network. You have just signed up for cable Internet access for the network. The cable company has installed the line into your home and given you a preconfigured modem for your network.
All connectors on the wall plate are for WAN connections only. You do not have LAN connections inside your home.
Connect the computer to the cable modem using a 10/100
Mbps Ethernet connection.
Use the AC to DC power adapter to plug in the modem.
![]() |
|
|||
---|---|---|---|---|
![]() |
|
Within the Networking Closet, use the appropriate twisted pair cable to make a connection between the patch panel and switch as follows:
Use port Supp on the patch panel
From the Shelf, expand the Networking Devices category.
Drag the DSL Router, to the bench between the computer and the wall outlets.
Use the appropriate cables to connect the DSL router to the phone connectors in the wall outlets and to the NIC port on the computer.
Use the Network and Sharing Center diagram to confirm the
workstation is connected to the Internet.
![]() |
|
|||
---|---|---|---|---|
![]() |
|
Inspect the activity lights on the switch to find the connection
that is not lit or blinking.
Select the cable plugged into the connection and make note of
the switch port number and the label on the patch panel.
Add the monitor to the office and connect it to the computer.
Use the DVID cable to connect the monitor to the computer.
![]() |
|
|
---|---|---|
You did not complete the lab correctly.
You have recently been hired as a network technician for a small corporate network. Today is your first day on the job and you need to continue to familiarize yourself with the network. You need to continue to work on the computer in Office 2 and go to the Networking Closet to test the rack mounted uninterruptible power supply (UPS).
After installing the network adapters, turn the computer back
on.
Install the networking cable between the wall plate and the computer (choose any of the 3 NICs that are now installed).
[netpro2015_lab_questions_en.exm EXM_INTRO3]
![]() |
|
---|
3. Use a wired connection from the PC to the network device.
4. Use cables that support Gigabit Ethernet.The list on the left identifies several cable types and devices that could be used for this scenario. Drag the appropriate cable type or device on the left to the corresponding location identified in the image.
|
|
|
---|---|---|
Explanation
Cable A: To connect to the Ethernet port in the wall plate, and to support Gigabit Ethernet, you need to use a Category 5e Ethernet Cable. Category 5 cable was originally intended to support Gigabit Ethernet but was discovered in practice, over time, to not reliably do so.