Select and install the network adapter that supports ethernet networks office

Passing Score: 80%

View results by:		Objective Analysis

You did not complete the lab correctly.

Use the AC to DC power adapter to connect the router to the surge protector.

Renew the IP configuration on Dorm­PC so it gets an IP address from the DHCP scope that is configured on the router.

Select and install the 1GB Ethernet network adapter to
connect to the local network.

Move the existing cable from the old NIC to the new NIC and
connect the computer to the local area network.

				Launch Lab
		To answer this question, complete the lab using information below.

In Office 2, connect the workstation to the local network using the cable that also supports 1GB Ethernet network speeds.

In the workstation's operating system (named Office2), confirm that the workstation has a connection to the local network and the Internet.

You did not complete the lab correctly.

The ping command utility

The network activity lights for all networking devices

[netpro2015_lab_questions_en.exm EXM_TRB_NET_COMM1]

You are a network technician for a small network. Your workstation just stopped communicating with all other computers in the network. You need to diagnose and fix the problem. For this lab, the following IP addresses are used:

The Network and Sharing Center in the Windows 7 or
Windows 2012 operating system

Fix the problem, and as necessary, use the known good spares on the Shelf.

Within the Support Office, connect the workstation (named Support) to the local area network using the appropriate twisted pair cable.

Within the Networking Closet, use the appropriate twisted pair cable to make a connection between the patch panel and switch as follows:

Lori wants to set up a SOHO network in her apartment. The apartment comes with a Gigabit Ethernet network already installed. Lori's notebook computer has an integrated wireless network adapter. Her printer has an Ethernet card, but is not wireless enabled. Your task is to select the appropriate devices and cables (without spending more than necessary) to set up a network that provides wireless access for Lori's laptop and wired access for her printer.

Match the labels for the components on the left to the locations where they need to be installed in Lori's home office on the right.

3. Cable Connection to Printer: To connect the printer to this SOHO network, you would use a Cat5e Cable. The Cat6 cable would also support Gigabit Ethernet but it would require spending more than is necessary on the cable.

[netpro2015_lab_questions_en.exm ENH D&D PRACTICE]